VFD HY Series Inverter HY04D023B 4kw 400hz Input Single Phase Ouput 3 Phase 220v

1)PID control; advanced calculus PID closed-loop arithmetic

2)Easy PLC function can realize 16 legs of speed and inverter control function;

3)Low output ratting torque 0.5HZ-150%,

4)Carrier adjustable by 16KHZ

5)AVR technique, for ensuring the inverter load capability;

6)Various control technique by both synchronization and non-synchronization

7)A potentiometer can be used to adjust to the rotation speed you want.

8)RS485 communication port, adopting standard international MODBUS main circuit control

9)Supports external potentiometer control,pls connect the "FOR" and "DCM" terminals,than set PD001=1

10) Supports mach3 function and RS-485 communication

• VFD's U= Spindle's 1
• VFD's V= Spindle's 2
• VFD's W= Spindle's 3
• Connect any "R" & "T" of the inverter to "220VAC" input wire.

Notice:

If your motor's speed is not 400hz 24000rpm,you need to change the drive parameters,then connect 3 phase motor,before you change the parameters,you need Factory Reset,then change PD013 to 8,then you can change the parameters.

Keyboard

• UP: Progressively increase data or function codes.
• DOWN: Progressively decrease data or function codes.
• RUN: Run key
• SET: Enter menus step-by-step, save setting parameters.
• PRGM: mainly used to switch monitoring state,exit to previous menu.Display output current.
• SHIFT: Switch monitoring parameters at monitoring state, at secondary menu, move data box to process editing position.
• JOG: FOR / REV switch

DC cooling fan

The inverter is equipped with a DC cooling fan, which has low noise and large air volume during operation,which is very conducive to heat dissipation and improves the stability of the product at work.

High performance montherboard

With overload,fuse broken-motor stops, over-voltage, low-voltage ,restarted by frequency track after instantaneous stop, electronic circuit,over-heat, running, direct start after power on, fault reset, parameter lock PID, ect.

Our inverter is running 400Hz 3 phase 220V motor by default.If your 3 phase motor is 400Hz, you can check the default setting and run it directly.

• pd003=400
• pd004=400
• pd005=400
• pd072=400
• pd144=3000

If your 3 phase 220V motor is 50Hz, please refer to the following settings.

• pd013=8 to restore factory settings first
• pd003=50
• pd004=50
• pd005=50
• pd072=50
• pd144=3450
• pd002=1
• pd070=1

If your 3 phase 220V motor is 60Hz, please refer to the following settings.

• pd013=8 to restore factory settings first
• pd003=60
• pd004=60
• pd005=60
• pd072=60
• pd144=3450
• pd002=1
• pd070=1